H-314-E adapter sleeve: complete specifications & mounting data

Specification table

Source: catalog reference (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 23.1 adapter sleeves for metric shafts) · extracted 2026-09-30

Parameters extracted from the official SKF Rolling Bearings catalogue (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 23.1 adapter sleeves for metric shafts); SKF® and SKF Explorer® are trademarks of AB SKF, used here for identification only — mpnbase is not an authorized SKF distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at skf.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the H-314-E model number is decoded

a width-to-bore ratio of 0.74 gives a 52 mm tapered contact length; the longitudinal slit lets the sleeve close down radially, so the grip on the 60 mm shaft is purely frictional the sleeve wall is 11 mm thick at the small end — 15.7% of the 70 mm bore — thin enough to contract evenly onto the 60 mm shaft while keeping the seat round under the clamping load mass 670 g is 9.6 g per mm of bore; the sleeve with its KMFE 14 nut forms the complete 52 mm-wide mounting assembly the 10 mm difference between the 60 mm shaft and the 70 mm nominal seat diameter is bridged by taper contraction as the slit sleeve closes during drive-up, rather than by machining the shaft the M 70x2 thread spans about 26.0 nut turns across the 52 mm width; each indexed turn is a measurable drive-up step when setting the bearing clearance on the 70 mm seat the 60 mm size is the volume tier of the range; the KMFE 14 nut and its locking element suit routine field replacement without special tooling H 314 E keeps the same 70x92x52 mm sleeve geometry as the plain H size; only the locking concept changes to the integrated device inside the KMFE 14 nut as part of the medium-section H 3 range, the default seat for 13..K and 22..K self-aligning ball bearings and 222..K spherical roller bearings, this size keeps series-standard proportions: 52 mm width on a 70 mm bore, so the bearing lands at the catalogue axial position the catalogue row bundles the KMFE 14 lock nut and references the HMV 14 E hydraulic nut for the 70 mm seat typical applications include printing press cylinder journals, textile machine roller shafts and conveyor pulley and drum bearing seats adapter sleeves earn their place wherever a tapered-bore bearing must sit at any axial position on a plain shaft — here a 70 mm bore bearing on a 60 mm shaft in conveyor pulley and drum bearing seats the sleeve lets the designer use a plain, unstepped shaft and still locate the bearing positively; only one shoulder is needed, opposite the KMFE 14 nut kit identity for this seat: sleeve H 314 E for a 60 mm shaft, 70x92x52 mm taper, M 70x2 thread, KMFE 14 self-locking nut, drive-up tool HMV 14 E, catalogue mass 670 g

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• neglecting the catalogue axial displacement value leaves the bearing either loose on the taper or preloaded hot in service
• over-driving the taper eliminates bearing internal clearance entirely; clearance reduction must be measured with feeler gauges, not estimated from nut torque
• driving the bearing via the outer ring during mounting loads the rolling elements; force is always applied through the lock nut on the inner ring