OH-3192-H adapter sleeve: complete specifications & mounting data

Specification table

Source: catalog reference (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 23.1 adapter sleeves for metric shafts) · extracted 2026-09-30

Parameters extracted from the official SKF Rolling Bearings catalogue (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 23.1 adapter sleeves for metric shafts); SKF® and SKF Explorer® are trademarks of AB SKF, used here for identification only — mpnbase is not an authorized SKF distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at skf.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the OH-3192-H model number is decoded

this sleeve mounts a bearing with a 460 mm tapered bore onto a plain 430 mm shaft; the 580 mm outside diameter and 326 mm width define the tapered seat the bearing is driven onto mass 119,000 g is 258.7 g per mm of bore; the sleeve with its HM 3192 nut and MS 3192-88 clip forms the complete 326 mm-wide mounting assembly oil reaches the interface through the M 8 duct connection into distribution grooves, so the 119,000 g sleeve can be floated off the 430 mm shaft instead of being pressed or pulled the seat taper is 1:12, so each millimetre of axial drive-up removes about 1/12 mm of radial clearance; one turn of the HM 3192 nut on the Tr 460x5 thread advances 5 mm and takes out roughly 0.417 mm of clearance the sleeve wall is 60 mm thick at the small end — 13.0% of the 460 mm bore — thin enough to contract evenly onto the 430 mm shaft while keeping the seat round under the clamping load at 430 mm shaft diameter this sleeve sits in the extra-large band served by oil-injection execution: pressurised oil between the mating surfaces is the only practical way to mount and dismount at this size the OH prefix names the oil-injection execution: ducts and distribution grooves in the tapered surface let pressurised oil part sleeve, shaft and bearing during mounting and dismounting; the trailing H marks the full hydraulic design dimensionally this sleeve belongs to the oil-injection OH 31 range for 231..K spherical roller bearings; the 580 mm OD and 326 mm width follow the ISO 2982-1 boundary plan for that series the delivery includes the HM 3192 lock nut and the MS 3192-88 locking clip, and the HMV 92E hydraulic nut is the associated drive-up tool typical applications include rolling mill and steel plant roll seats, pump shafts in water and process plants and textile machine roller shafts adapter sleeves earn their place wherever a tapered-bore bearing must sit at any axial position on a plain shaft — here a 460 mm bore bearing on a 430 mm shaft in textile machine roller shafts the sleeve lets the designer use a plain, unstepped shaft and still locate the bearing positively; only one shoulder is needed, opposite the HM 3192 nut ordering digest — OH 3192 H: 430 mm plain shaft to 460 mm tapered bore, sleeve 580 mm OD and 326 mm wide, thread Tr 460x5, supplied with HM 3192 nut with MS 3192-88 clip, drive-up tool HMV 92E; listed mass is 119,000 g

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• greasing the tapered seat or shaft destroys the dry friction the joint relies on; a lubricated taper can let the whole sleeve spin under load
• neglecting the catalogue axial displacement value leaves the bearing either loose on the taper or preloaded hot in service
• blocked or contaminated oil ducts fail exactly at peak dismounting pressure; flush and blank the M 8 connection after each use