C41-600-MB bearing: complete specifications & equivalents

Specification table

Source: catalog reference (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 10.1 CARB toroidal roller bearings) · extracted 2026-09-27

Parameters extracted from the official SKF Rolling Bearings catalogue (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 10.1 CARB toroidal roller bearings); SKF® and SKF Explorer® are trademarks of AB SKF, used here for identification only — mpnbase is not an authorized SKF distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at skf.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the C41-600-MB model number is decoded

C 41/600 MB is the dimension series 41 CARB toroidal roller bearings member of the CARB range: 600 mm bore, 980 mm OD, 375 mm width, with the asymmetrical-looking toroidal roller set that defines the CARB principle. The designation C 41/600 MB separates into C (CARB), 41 (dimension series), 600 mm (slash-size) (600 mm bore — bore 600 mm is written directly after the slash) and MB (cylindrical bore for direct shaft fitting, machined inner-ring-guided brass cage (MB)); envelope 600×980×375 mm follows the ISO 15 plan. The cylindrical 600 mm bore mounts directly on a machined seat; the outer ring takes a loose housing fit so the bearing can float axially. The same size is listed in both bore executions, and the boundary dimensions 600×980×375 mm are identical — only the mounting method changes. The 1150000 g mass over the 600×980×375 mm envelope yields about 21.50 kN dynamic per millimetre of bore — the long toroidal rollers give this family its radial capacity density. Open executions accept relubrication — route it through the outer-ring groove on sizes that have one and purge stale grease at service intervals. Grease through the annular groove features where provided; on open executions feed lubricant past the long roller set at assembly, since the 375 mm wide cavity does not fill itself.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• At 600 mm bore the 1150 kg mass and 375 mm width make seating geometry dominant: sphered-washer seats and oil flow must be verified in place, not just on the drawing.
• Reference and limiting speeds are different limits: the 340 r/min reference speed is the thermal criterion under load, the limiting value is the mechanical ceiling; observe the reference under load unless the arrangement calculation says otherwise.
• The quoted 12900/23200 kN ratings belong to this exact execution (C 41/600 MB); VE240 vibrating-screen variants and sealed 2CS/2NS variants have their own figures even at the same envelope.
• Do not block the axial displacement in the drawing: housing covers, labyrinth rings and snap rings must leave the catalogue float (s) free, or the bearing silently becomes a poorly located fixed bearing.
• Envelope-identical spherical roller bearings (same ISO 15 d×D×B) are not drop-in equivalents — they locate the shaft axially, while C 41/600 MB must float; the two are designed to be used as a pair.
• The 12900/23200 kN ratings and 1150000 g mass are SKF catalogue values transcribed from ch. 10.1 of PUB BU/P1 17000 (PDF table page 866); mounting data — axial displacement (s) and seating details — appears in the running text because the structured record carries the boundary envelope only.