SL014938 bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the SL014938 model number is decoded

envelope 190×260×69 mm with a 35.0 mm radial section; every available circumferential space carries a roller because there is no cage C is 580 kN and C0 1270 kN; with a C/C0 ratio of 0.46 the 69 mm-wide full complement concentrates on extreme static and steady radial capacity rather than speed the fatigue load limit Cur is 155 kN, the limiting speed 1,410 r/min and the thermal reference speed 860 r/min — full-complement roller-to-roller contact keeps both speeds well below caged cylindrical bearings of the same size the dynamic rating is 3.05 kN per millimetre of the 190 mm bore and 8.41 kN per millimetre of the 69 mm width, figures that explain the use of this bearing in compact, heavily loaded gearbox positions mass is 11.2 kg (11200 g) (0.62 g per mm² of the 260×69 mm envelope); the stiff, thick rings keep raceway deformation low under peak loads 190 mm bore, 260 mm outside diameter: at this size the 1270 kN C0 rating and rigid full-complement pack replace multi-bearing arrangements in compact heavy-duty designs SL0149 is the double-row full-complement locating bearing: it supports the radial load and axial loads in both directions, fixing the shaft axially at that position Inside the 190×260×69 mm envelope the two cageless rows provide C0 1270 kN, the capacity this series is selected for in heavy gearbox and drum positions Typical applications include marine and offshore winch arrangements, rope drums and winch drums and hydraulic pumps and radial piston pumps, where the 260 mm outside diameter and 580 kN dynamic rating match the duty. In marine and offshore winch arrangements the unit fits a compact 190 mm seat, and in rope drums and winch drums the 11.2 kg mass is part of the rotor inertia calculation. Designers also specify it for hydraulic pumps and radial piston pumps, relying on the 69 mm width and the published 1270 kN static rating. Relubrication paths matter: specify the annular groove/hole executions where access is poor, because the tightly packed rows trap old grease. There is no cage: do not apply caged-bearing speed rules — the printed limiting speed is a hard kinematic ceiling set by roller-to-roller contact.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Relubrication paths matter: specify the annular groove/hole executions where access is poor, because the tightly packed rows trap old grease.
• There is no cage: do not apply caged-bearing speed rules — the printed limiting speed is a hard kinematic ceiling set by roller-to-roller contact.
• Use the rib structure correctly: SL18/SL1850 give one-direction axial guidance, SL0149 locates both ways and SL0249 floats — pairing two locating bearings on one shaft binds thermal growth.