SL024916 bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the SL024916 model number is decoded

envelope 80×110×30 mm with a 15.0 mm radial section; every available circumferential space carries a roller because there is no cage C is 112 kN and C0 206 kN; with a C/C0 ratio of 0.54 the 30 mm-wide full complement concentrates on extreme static and steady radial capacity rather than speed the fatigue load limit Cur is 30.5 kN, the limiting speed 3,550 r/min and the thermal reference speed 2,090 r/min — full-complement roller-to-roller contact keeps both speeds well below caged cylindrical bearings of the same size the dynamic rating is 1.40 kN per millimetre of the 80 mm bore and 3.73 kN per millimetre of the 30 mm width, figures that explain the use of this bearing in compact, heavily loaded gearbox positions mass is 850 g (0.26 g per mm² of the 110×30 mm envelope); the stiff, thick rings keep raceway deformation low under peak loads at 80 mm bore the 110 mm outside diameter and 30 mm width target rolling stands, construction machinery and heavy gearboxes; the limiting speed drops to 3,550 r/min The non-locating structure has two inner rings with side ribs and a plain outer ring joined by retaining rings for handling; axial displacement of shaft relative to housing occurs inside the bearing without constraint Two full roller rows give C 112 kN and C0 206 kN in a 110 mm outside diameter — the classic floating position opposite an SL0149 locating bearing Typical applications include construction machinery slewing drives, material handling conveyor pulleys and planetary gear bearing positions, where the 110 mm outside diameter and 112 kN dynamic rating match the duty. In construction machinery slewing drives the unit fits a compact 80 mm seat, and in material handling conveyor pulleys the 850 g mass suits the compact, space-optimised housing. Designers also specify it for planetary gear bearing positions, relying on the 30 mm width and the published 206 kN static rating. C0 is the number that tempts overload in slow machinery, but fatigue life is still governed by the dynamic C rating and lubricant film. The bearings cannot accommodate angular misalignment; check shaft and housing parallelism before blaming the bearing for edge spalling.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• C0 is the number that tempts overload in slow machinery, but fatigue life is still governed by the dynamic C rating and lubricant film.
• The bearings cannot accommodate angular misalignment; check shaft and housing parallelism before blaming the bearing for edge spalling.
• Use the rib structure correctly: SL18/SL1850 give one-direction axial guidance, SL0149 locates both ways and SL0249 floats — pairing two locating bearings on one shaft binds thermal growth.