SL024926 bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the SL024926 model number is decoded

envelope 130×180×50 mm with a 25.0 mm radial section; every available circumferential space carries a roller because there is no cage C is 260 kN and C0 510 kN; with a C/C0 ratio of 0.51 the 50 mm-wide full complement concentrates on extreme static and steady radial capacity rather than speed the fatigue load limit Cur is 64 kN, the limiting speed 2,090 r/min and the thermal reference speed 1,500 r/min — full-complement roller-to-roller contact keeps both speeds well below caged cylindrical bearings of the same size the dynamic rating is 2.00 kN per millimetre of the 130 mm bore and 5.20 kN per millimetre of the 50 mm width, figures that explain the use of this bearing in compact, heavily loaded gearbox positions mass is 3.8 kg (3800 g) (0.42 g per mm² of the 180×50 mm envelope); the stiff, thick rings keep raceway deformation low under peak loads 130 mm bore, 180 mm outside diameter: at this size the 510 kN C0 rating and rigid full-complement pack replace multi-bearing arrangements in compact heavy-duty designs SL0249 is the double-row full-complement non-locating (floating) bearing: the flangeless outer ring moves freely over the rollers, taking only radial load while a separate bearing locates the shaft Two full roller rows give C 260 kN and C0 510 kN in a 180 mm outside diameter — the classic floating position opposite an SL0149 locating bearing Typical applications include vibrating and oscillating machinery, heavy industrial gearbox shafts and rope drums and winch drums, where the 180 mm outside diameter and 260 kN dynamic rating match the duty. In vibrating and oscillating machinery the unit fits a compact 130 mm seat, and in heavy industrial gearbox shafts the 3.8 kg mass is part of the rotor inertia calculation. Designers also specify it for rope drums and winch drums, relying on the 50 mm width and the published 510 kN static rating. Relubrication paths matter: specify the annular groove/hole executions where access is poor, because the tightly packed rows trap old grease. There is no cage: do not apply caged-bearing speed rules — the printed limiting speed is a hard kinematic ceiling set by roller-to-roller contact.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Relubrication paths matter: specify the annular groove/hole executions where access is poor, because the tightly packed rows trap old grease.
• There is no cage: do not apply caged-bearing speed rules — the printed limiting speed is a hard kinematic ceiling set by roller-to-roller contact.
• Use the rib structure correctly: SL18/SL1850 give one-direction axial guidance, SL0149 locates both ways and SL0249 floats — pairing two locating bearings on one shaft binds thermal growth.