SL024956 bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the SL024956 model number is decoded

envelope 280×380×100 mm with a 50.0 mm radial section; every available circumferential space carries a roller because there is no cage C is 1150 kN and C0 2650 kN; with a C/C0 ratio of 0.43 the 100 mm-wide full complement concentrates on extreme static and steady radial capacity rather than speed the fatigue load limit Cur is 300 kN, the limiting speed 940 r/min and the thermal reference speed 520 r/min — full-complement roller-to-roller contact keeps both speeds well below caged cylindrical bearings of the same size the dynamic rating is 4.11 kN per millimetre of the 280 mm bore and 11.50 kN per millimetre of the 100 mm width, figures that explain the use of this bearing in compact, heavily loaded gearbox positions mass is 33.1 kg (33100 g) (0.87 g per mm² of the 380×100 mm envelope); the stiff, thick rings keep raceway deformation low under peak loads 280 mm bore, 380 mm outside diameter: at this size the 2650 kN C0 rating and rigid full-complement pack replace multi-bearing arrangements in compact heavy-duty designs SL0249 is the double-row full-complement non-locating (floating) bearing: the flangeless outer ring moves freely over the rollers, taking only radial load while a separate bearing locates the shaft Shaft and housing shoulders must still locate the rings themselves even though the bearing floats internally; the 50.0 mm section ring is too stiff to self-align Typical applications include rolling-mill and steel-industry drives, hydraulic pumps and radial piston pumps and material handling conveyor pulleys, where the 380 mm outside diameter and 1150 kN dynamic rating match the duty. In rolling-mill and steel-industry drives the unit fits a compact 280 mm seat, and in hydraulic pumps and radial piston pumps the 33.1 kg mass is part of the rotor inertia calculation. Designers also specify it for material handling conveyor pulleys, relying on the 100 mm width and the published 2650 kN static rating. Use the rib structure correctly: SL18/SL1850 give one-direction axial guidance, SL0149 locates both ways and SL0249 floats — pairing two locating bearings on one shaft binds thermal growth. There is no cage: do not apply caged-bearing speed rules — the printed limiting speed is a hard kinematic ceiling set by roller-to-roller contact.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Use the rib structure correctly: SL18/SL1850 give one-direction axial guidance, SL0149 locates both ways and SL0249 floats — pairing two locating bearings on one shaft binds thermal growth.
• There is no cage: do not apply caged-bearing speed rules — the printed limiting speed is a hard kinematic ceiling set by roller-to-roller contact.
• C0 is the number that tempts overload in slow machinery, but fatigue life is still governed by the dynamic C rating and lubricant film.