SL183048 bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the SL183048 model number is decoded

envelope 240×360×92 mm with a 60.0 mm radial section; every available circumferential space carries a roller because there is no cage C is 1210 kN and C0 1990 kN; with a C/C0 ratio of 0.61 the 92 mm-wide full complement concentrates on extreme static and steady radial capacity rather than speed the fatigue load limit Cur is 234 kN, the limiting speed 1,040 r/min and the thermal reference speed 720 r/min — full-complement roller-to-roller contact keeps both speeds well below caged cylindrical bearings of the same size the dynamic rating is 5.04 kN per millimetre of the 240 mm bore and 13.15 kN per millimetre of the 92 mm width, figures that explain the use of this bearing in compact, heavily loaded gearbox positions mass is 30.9 kg (30900 g) (0.93 g per mm² of the 360×92 mm envelope); the stiff, thick rings keep raceway deformation low under peak loads 240 mm bore, 360 mm outside diameter: at this size the 1990 kN C0 rating and rigid full-complement pack replace multi-bearing arrangements in compact heavy-duty designs Reading the designation: SL18 marks the Schaeffler full-complement semi-locating type with one rib on the outer ring and two ribs on the inner ring; the rollers are axially guided by the inner ring while the outer ring can displace by the catalogue s-value The semi-locating function means this bearing locates the shaft in one axial direction and floats in the other — useful in two-bearing shafts where one position is fixed and the other absorbs expansion Typical applications include construction machinery slewing drives, material handling conveyor pulleys and planetary gear bearing positions, where the 360 mm outside diameter and 1210 kN dynamic rating match the duty. In construction machinery slewing drives the unit fits a compact 240 mm seat, and in material handling conveyor pulleys the 30.9 kg mass is part of the rotor inertia calculation. Designers also specify it for planetary gear bearing positions, relying on the 92 mm width and the published 1990 kN static rating. C0 is the number that tempts overload in slow machinery, but fatigue life is still governed by the dynamic C rating and lubricant film. The bearings cannot accommodate angular misalignment; check shaft and housing parallelism before blaming the bearing for edge spalling.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• C0 is the number that tempts overload in slow machinery, but fatigue life is still governed by the dynamic C rating and lubricant film.
• The bearings cannot accommodate angular misalignment; check shaft and housing parallelism before blaming the bearing for edge spalling.
• Use the rib structure correctly: SL18/SL1850 give one-direction axial guidance, SL0149 locates both ways and SL0249 floats — pairing two locating bearings on one shaft binds thermal growth.