NKI70-35-XL bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the NKI70-35-XL model number is decoded

envelope 70×95×35 mm: 70 mm bore accepts a normal-tolerance machined shaft via the integral inner ring, with a thin 12.5 mm radial section packed with small-diameter needle rollers C is 89 kN and C0 184 kN at the 70 mm seat; the C/C0 ratio of 0.48 is characteristic of a needle bearing — high static rating relative to dynamic in a compact 95 mm outside diameter the fatigue load limit Cur is 33 kN, the limiting speed 5,800 r/min and the thermal reference speed 3,350 r/min; for small needle bearings the reference speed can exceed the kinematic limit, so the lower of the two governs the application dynamic capacity per millimetre of bore is 1.27 kN/mm and per millimetre of width 2.54 kN/mm — the reason 35 mm-wide needle bearings routinely replace much larger ball or roller positions mass is 737 g, just 0.22 g per mm² of projected 95×35 mm envelope, which keeps unbalanced forces low in fast-actuating linkages with a 70 mm bore this is a heavy-industrial bearing: 737 g of stiff ring and roller set, specified where rigidity matters more than speed Cur 33 kN, limiting speed 5,800 r/min, reference speed 3,350 r/min — the inner ring adds a few grams (total 737 g) but removes the hardening requirement Reading the NKI prefix: machined-ring needle bearing with inner ring, one roller row, capable of pure radial load at 89 kN C X-life status (-XL) indicates the current Schaeffler premium execution at 70 mm bore; the 184 kN C0 rating reflects the improved rolling-contact geometry. Typical applications include agricultural machine pivots and linkages, hydraulic and pneumatic pump eccentrics and textile machine heald and cam shafts, where the 95 mm outside diameter and 89 kN dynamic rating match the duty. In agricultural machine pivots and linkages the unit fits a compact 70 mm seat, and in hydraulic and pneumatic pump eccentrics the 737 g mass keeps unbalanced forces low in fast linkages. Designers also specify it for textile machine heald and cam shafts, relying on the 35 mm width and the published 184 kN static rating. Keep the specified radial clearance; an oversized shaft or heavy interference removes it and the needles bind hot immediately. Do not press an RNA/NK assembly in through the outer ring when mounting it on a shaft, and vice versa — rolling forces through the wrong ring bruises the raceways.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Keep the specified radial clearance; an oversized shaft or heavy interference removes it and the needles bind hot immediately.
• Do not press an RNA/NK assembly in through the outer ring when mounting it on a shaft, and vice versa — rolling forces through the wrong ring bruises the raceways.
• Open ends draw contamination directly onto the needles; specify sealed or shielded positions in dusty environments rather than relying on grease alone.