NKIS20-XL bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the NKIS20-XL model number is decoded

envelope 20×42×20 mm: 20 mm bore accepts a normal-tolerance machined shaft via the integral inner ring, with a thin 11.0 mm radial section packed with small-diameter needle rollers C is 32.5 kN and C0 36.5 kN at the 20 mm seat; the C/C0 ratio of 0.89 is characteristic of a needle bearing — high static rating relative to dynamic in a compact 42 mm outside diameter the fatigue load limit Cur is 6.5 kN, the limiting speed 15,100 r/min and the thermal reference speed 7,700 r/min; for small needle bearings the reference speed can exceed the kinematic limit, so the lower of the two governs the application dynamic capacity per millimetre of bore is 1.63 kN/mm and per millimetre of width 1.63 kN/mm — the reason 20 mm-wide needle bearings routinely replace much larger ball or roller positions mass is 129 g, just 0.15 g per mm² of projected 42×20 mm envelope, which keeps unbalanced forces low in fast-actuating linkages the 20 mm bore falls in the small band, the workhorse size for gearbox planetary positions, hydraulic pumps and general cam and linkage duty The 11.0 mm section still holds a full needle pack; like all needle bearings it cannot tolerate angular misalignment, so shaft and housing axes must be parallel Reading the NKIS prefix: machined-ring needle bearing with inner ring, one roller row, capable of pure radial load at 32.5 kN C The -XL suffix marks the X-life execution: refined raceway topography and upgraded materials lift the basic ratings versus the non-X-life bearing at the same 20×42×20 mm envelope. Typical applications include hydraulic and pneumatic pump eccentrics, copying and printing machine mechanisms and agricultural machine pivots and linkages, where the 42 mm outside diameter and 32.5 kN dynamic rating match the duty. In hydraulic and pneumatic pump eccentrics the unit fits a compact 20 mm seat, and in copying and printing machine mechanisms the 129 g mass keeps unbalanced forces low in fast linkages. Designers also specify it for agricultural machine pivots and linkages, relying on the 20 mm width and the published 36.5 kN static rating. Without an inner ring the shaft is the raceway: 58–64 HRC and a ground, polished journal are mandatory, not recommendations. Adding an IR inner ring changes the envelope logic: the same outer assembly then fits a smaller shaft — recheck bore, clearance and ratings when substituting.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Without an inner ring the shaft is the raceway: 58–64 HRC and a ground, polished journal are mandatory, not recommendations.
• Adding an IR inner ring changes the envelope logic: the same outer assembly then fits a smaller shaft — recheck bore, clearance and ratings when substituting.
• Keep the specified radial clearance; an oversized shaft or heavy interference removes it and the needles bind hot immediately.