RNA69-22-XL bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the RNA69-22-XL model number is decoded

envelope 28×39×30 mm: 28 mm seat is the hardened and ground shaft journal itself — there is no inner ring, with a thin 5.5 mm radial section packed with small-diameter needle rollers C is 42 kN and C0 55 kN at the 28 mm seat; the C/C0 ratio of 0.76 is characteristic of a needle bearing — high static rating relative to dynamic in a compact 39 mm outside diameter the fatigue load limit Cur is 10 kN, the limiting speed 15,300 r/min and the thermal reference speed 8,400 r/min; for small needle bearings the reference speed can exceed the kinematic limit, so the lower of the two governs the application dynamic capacity per millimetre of bore is 1.50 kN/mm and per millimetre of width 1.40 kN/mm — the reason 30 mm-wide needle bearings routinely replace much larger ball or roller positions mass is 98 g, just 0.08 g per mm² of projected 39×30 mm envelope, which keeps unbalanced forces low in fast-actuating linkages at 28 mm bore this size balances the 39 mm outside diameter against machineability of the adjacent parts — the most frequently specified band in the HR1 range The hardness requirement is unforgiving: below about 58 HRC the 28 mm journal brinels under the 55 kN static rating, and roughness above raceway finish accelerates roller wear X-life status (-XL) indicates the current Schaeffler premium execution at 28 mm bore; the 55 kN C0 rating reflects the improved rolling-contact geometry. Typical applications include rocker arms and valve trains, two-stroke and compressor piston pins and small electric motor accessory drives, where the 39 mm outside diameter and 42 kN dynamic rating match the duty. In rocker arms and valve trains the unit fits a compact 28 mm seat, and in two-stroke and compressor piston pins the 98 g mass keeps unbalanced forces low in fast linkages. Designers also specify it for small electric motor accessory drives, relying on the 30 mm width and the published 55 kN static rating. Do not press an RNA/NK assembly in through the outer ring when mounting it on a shaft, and vice versa — rolling forces through the wrong ring bruises the raceways. On reciprocating duty ensure the stroke rotates the full needle set, or brinelling occurs at the same roller positions.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Do not press an RNA/NK assembly in through the outer ring when mounting it on a shaft, and vice versa — rolling forces through the wrong ring bruises the raceways.
• On reciprocating duty ensure the stroke rotates the full needle set, or brinelling occurs at the same roller positions.
• Adding an IR inner ring changes the envelope logic: the same outer assembly then fits a smaller shaft — recheck bore, clearance and ratings when substituting.