430213X bearing: complete specifications & equivalents

Specification table

Source: catalog reference (NTN 2203E 2026-09-25) · extracted 2026-10-01

Parameters extracted from the official NTN Ball and Roller Bearings catalogue (NTN 2203E 2026-09-25); NTN® is a trademark of NTN Corporation, used here for identification only — mpnbase is not an authorized NTN distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at ntnglobal.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the 430213X model number is decoded

4T-430213X is the NTN 4T catalogue entry for a 65×120×56 mm double-row tapered roller bearing — the TDO arrangement reacts radial load plus thrust in both directions without a second bearing. Large sizes continue the plans under different leading digits: 4130/4131 and 4230/4231 belong to the 430-family dimension plan, while 3230/3231 continue the 432 heavy plan — 430213X reads accordingly. Speed planning uses both catalogue columns: grease 2,600 r/min is the mechanical ceiling, oil 3,500 r/min with oil lubrication — a 900 r/min margin at this size. TDO construction means the two cone assemblies of 4T-430213X face away from each other inside one double cup: the load lines diverge outward, giving a wide effective spread and high moment stiffness for the 65 mm shaft. At 234 kN C the unit offers about 3.6 kN per millimetre of the 65 mm bore — heavy-section TDO rows of this class run warm, so confirm oil availability before working near 3,500 r/min.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Mount the 65 mm unit by induction heating (max 120 °C); at 2.56 kg a cocked lift damages the cages and ribs before the bearing ever runs.
• The 430 light plan keeps 4T-430213X narrower and faster than the 432 heavy execution of the same 65 mm bore; where shock or a high thrust share dominates, verify whether the heavier 432-family row is the intended position.
• The 27.5 mm section leaves little room for oversized shaft fillets; follow the 2203E chamfer table for 4T-430213X or the cones bottom out on the radius.
• Order by the full 430213X code including suffixes — U, X, DX, E1 and UTG variants share the 65 mm bore but are different articles with different internal geometry.
• Order by the full 430213X code including suffixes — U, X, DX, E1 and UTG variants share the 65 mm bore but are different articles with different internal geometry.
• The 234/295 kN ratings here are NTN Ball and Roller Bearings CAT.No.2203E figures for 4T-430213X; internal geometry legitimately differs between manufacturers, so re-verify ratings, clearance class and suffix before substituting another make on a rated drive.