432232UUTG bearing: complete specifications & equivalents

Specification table

Source: catalog reference (NTN 2203E 2026-09-25) · extracted 2026-10-01

Parameters extracted from the official NTN Ball and Roller Bearings catalogue (NTN 2203E 2026-09-25); NTN® is a trademark of NTN Corporation, used here for identification only — mpnbase is not an authorized NTN distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at ntnglobal.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the 432232UUTG model number is decoded

For a 160 mm shaft needing a compact two-direction thrust location, NTN lists 4T-432232UUTG, a TDO double-row 4T unit of 1960 kN C and 2840 kN C0 in the heavy-duty 432-family TDO double-row series. The 4T- prefix is NTN's tapered roller quality mark; 430 numbers the light TDO plan and 432 the heavy TDO plan — at the same 160 mm bore the 432 execution carries a wider, heavier section than the 430. Grease relubrication at the 1,000 r/min limiting speed must reach both roller rows; sustaining 1,400 r/min needs an oil supply with defined flow through the double cup. Because the unit is preset, mounting 4T-432232UUTG resembles mounting a double-row spherical or cylindrical bearing: seat the unit, clamp axially to the stated end cover torque, and verify rotation — no end-play measurement is required. At 1960 kN C the unit offers about 12.3 kN per millimetre of the 160 mm bore — heavy-section TDO rows of this class run warm, so confirm oil availability before working near 1,400 r/min.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• At 160 mm bore the 4T-432232UUTG unit needs hydraulic or crane-assisted fitting and a verified oil supply; manual methods cannot control seating at the 1960 kN C level.
• The 432 heavy plan gives 4T-432232UUTG its 178 mm width and 1960 kN rating at the 160 mm bore; do not downgrade to a 430-family unit of the same bore without re-checking C, C0 and the 272 kN Cu.
• The 65.0 mm section leaves little room for oversized shaft fillets; follow the 2203E chamfer table for 4T-432232UUTG or the cones bottom out on the radius.
• Order by the full 432232UUTG code including suffixes — U, X, DX, E1 and UTG variants share the 160 mm bore but are different articles with different internal geometry.
• Order by the full 432232UUTG code including suffixes — U, X, DX, E1 and UTG variants share the 160 mm bore but are different articles with different internal geometry.
• The 1960/2840 kN ratings and 272 kN Cu here are NTN Ball and Roller Bearings CAT.No.2203E figures for 4T-432232UUTG; internal geometry legitimately differs between manufacturers, so re-verify ratings, clearance class and suffix before substituting another make on a rated drive.