NATV40-PP bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the NATV40-PP model number is decoded

envelope 40×80×32 mm: the 80 mm outside diameter is the track-running surface — a thick-walled outer ring over a 40 mm bore — and the 32 mm width sets the contact width on the mating track the catalogue lists C 40 kN and C0 89 kN for the NATV full-complement yoke-type track roller with axial guidance; the C/C0 ratio of 0.45 reflects a rolling-element pack sized for heavy static track loading, and the 20.0 mm radial section gives the outer ring its bending stiffness fatigue load limit Cur is 13.2 kN at 40 mm bore, equivalent to 1.00 kN of dynamic rating per millimetre — the limiting speed is 650 r/min and, as for HR1 track rollers, no thermal reference speed is published the 40 mm bore takes the mounting pin or shaft; across the 32 mm contact width the dynamic rating works out to 1.25 kN per millimetre of rolling-element complement mass is 832 g, or 0.33 g per mm² of the 80×32 mm track envelope — inertia that the drive must accelerate on every index of the cam at 40 mm pin bore this is a mainstream industrial size — conveyor drives, winches and medium gearboxes use the 32 mm width as a standard mounting space The cageless rollers can brinell on very short oscillating strokes — the motion must rotate the full pack, not just rock it At 40 mm bore and 832 g the roller mounts on a standard pin; yoke mounting means the pin, not a stud, carries the clamp load Reading -PP: rubbing seals at each face of the 80 mm outer ring; they protect the rolling-element pack in abrasive track environments at the cost of a small drag torque. Typical applications include woodworking machine feed tracks, cam drives and indexing tables and packaging machine timing mechanisms, where the 80 mm track diameter and 40 kN dynamic rating match the duty. In woodworking machine feed tracks the unit fits a compact 40 mm seat, and in cam drives and indexing tables the 832 g mass keeps follower kinetics light. Designers also specify it for packaging machine timing mechanisms, relying on the 32 mm width and the published 89 kN static rating. Sealed PP/2RSR units are greased for life: never add a grease nipple, and respect the lower limiting speed imposed by the rubbing lips. Yoke lugs must support the pin on both sides over its full length — single-sided support turns the pin into a cantilever beam.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Sealed PP/2RSR units are greased for life: never add a grease nipple, and respect the lower limiting speed imposed by the rubbing lips.
• Yoke lugs must support the pin on both sides over its full length — single-sided support turns the pin into a cantilever beam.
• The crowned outer profile tolerates only small skew; a track that departs by more than the catalogue angle still causes edge loading.