PWTR-2052-2RS bearing: complete specifications & equivalents

Specification table

Source: catalog reference (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 15 support rollers / ch. 16 cam followers) · extracted 2026-09-30

Parameters extracted from the official SKF Rolling Bearings catalogue (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 15 support rollers / ch. 16 cam followers); SKF® and SKF Explorer® are trademarks of AB SKF, used here for identification only — mpnbase is not an authorized SKF distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at skf.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the PWTR-2052-2RS model number is decoded

the 52 mm outside diameter runs on the track while the 20 mm bore takes the pin or shaft; the 25 mm overall width spreads the Hertzian contact over the outer ring published ratings C 25.5 kN and C0 29 kN already include the bending-stress correction for the unsupported outer ring — the C/C0 ratio of 0.88 is typical for sealed double-row full-complement support roller with integral flanges executions fatigue load limit Pu 3.35 kN at 20 mm bore gives a specific load of 1.27 kN per mm; the limiting speed is 3,800 r/min the 25 mm width carries the load at 1.02 kN per mm of roller complement; section height 16.0 mm between bore and track surface determines the outer-ring bending stiffness mass 320 g over a 52x25 mm envelope works out to 0.246 g per mm² of projected area — a useful figure when sizing the drive inertia for medium-speed cam duty the 20 mm bore falls in the small-size band, the most common choice for general-purpose cam followers and light conveyor transfer rollers the PWTR prefix marks the sealed version of the double-row full-complement design — the 25 mm width encloses two cylindrical roller sets with integral flanges and rubbing seals typical applications include printing press roller followers, automotive welding jig positioners and conveyor transfer and diverting rollers this size is commonly specified for printing press roller followers and automotive welding jig positioners, where the 52 mm track diameter and 20 mm bore fit standard cam and rail geometries in conveyor transfer and diverting rollers the 52 mm outer ring provides the rolling contact while the inner ring bore simplifies mounting; the 320 g mass is low enough for rapid indexing cycles the sealed outer ring cannot be inspected without destroying the seals; plan replacement on a time or cycle basis rather than condition monitoring the 2RS seals protect the roller rows but limit relubrication options; the unit is effectively sealed for life

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• the 2RS seals protect the roller rows but limit relubrication options; the unit is effectively sealed for life
• the sealed outer ring cannot be inspected without destroying the seals; plan replacement on a time or cycle basis rather than condition monitoring
• the integral flanges and seals add width; verify the track channel accommodates the full B dimension plus flange protrusion