RNA2202-2RSR bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the RNA2202-2RSR model number is decoded

envelope 20×35×13.8 mm: the 35 mm outside diameter is the track-running surface — a thick-walled outer ring over a 20 mm bore — and the 13.8 mm width sets the contact width on the mating track the catalogue lists C 7.6 kN and C0 9.9 kN for the RNA22 sealed yoke-type track roller without inner ring; the C/C0 ratio of 0.77 reflects a rolling-element pack sized for heavy static track loading, and the 7.5 mm radial section gives the outer ring its bending stiffness fatigue load limit Cur is 1.39 kN at 20 mm bore, equivalent to 0.38 kN of dynamic rating per millimetre — the limiting speed is 3,400 r/min and, as for HR1 track rollers, no thermal reference speed is published the 20 mm bore takes the mounting pin or shaft; across the 13.8 mm contact width the dynamic rating works out to 0.55 kN per millimetre of rolling-element complement mass is 60 g, or 0.12 g per mm² of the 35×13.8 mm track envelope — inertia that the drive must accelerate on every index of the cam the 20 mm pin bore falls in the small band, the workhorse size for gearbox planetary positions, hydraulic pumps and general cam and linkage duty C 7.6 kN, C0 9.9 kN and Cur 1.39 kN are the track-load ratings; the sealed lips reduce the limiting speed to 3,400 r/min The sealed pack is greased for life — additional lubrication is neither possible nor required, and the roller suits dirty positions with no maintenance access The 2RSR suffix fits elastomer contact seals on both sides, retaining the life-long grease fill behind the 35 mm outer ring. Typical applications include printing press sheet-transfer grippers, glass and ceramic line conveyors and cam drives and indexing tables, where the 35 mm track diameter and 7.6 kN dynamic rating match the duty. In printing press sheet-transfer grippers the unit fits a compact 20 mm seat, and in glass and ceramic line conveyors the 60 g mass keeps follower kinetics light. Designers also specify it for cam drives and indexing tables, relying on the 13.8 mm width and the published 9.9 kN static rating. The crowned outer profile tolerates only small skew; a track that departs by more than the catalogue angle still causes edge loading. Sealed PP/2RSR units are greased for life: never add a grease nipple, and respect the lower limiting speed imposed by the rubbing lips.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• The crowned outer profile tolerates only small skew; a track that departs by more than the catalogue angle still causes edge loading.
• Sealed PP/2RSR units are greased for life: never add a grease nipple, and respect the lower limiting speed imposed by the rubbing lips.
• Full-complement NATV/NUTR/PWTR rollers make heat and flat-spot easily — slow continuous rotation is fine, stationary load on a turning track is not.