NUP213-ECP bearing: complete specifications & equivalents

Specification table

Source: catalog reference (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 6.1 single-row cylindrical roller bearings) · extracted 2026-09-26

Parameters extracted from the official SKF Rolling Bearings catalogue (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 6.1 single-row cylindrical roller bearings); SKF® and SKF Explorer® are trademarks of AB SKF, used here for identification only — mpnbase is not an authorized SKF distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at skf.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the NUP213-ECP model number is decoded

For a 65 mm shaft, SKF lists NUP213-ECP as single-row caged cylindrical roller: 120 mm OD, 23 mm wide, Pu 15.6 kN, the catalogue lists 6,300 r/min thermal reference speed and 6,700 r/min mechanical limiting speed. Reading the NUP prefix: two integral flanges on the outer ring plus one integral flange and one loose flange ring on the inner ring. This makes the execution a locating bearing that positions the shaft axially in both directions while keeping the cylindrical-roller radial capacity. The ECP suffix marks the E-design execution with a glass-fibre reinforced polyamide (PA66) cage, limited to 120 °C continuous. The glass-fibre reinforced polyamide (PA66) window-type cage is reflected in the published speeds and temperature limits. With C 122 kN and C0 118 kN, size the bearing on the 65×120 mm ISO 15 envelope and check the 15.6 kN Pu against the equivalent-load floor; the catalogue lists 6,300 r/min thermal reference speed and 6,700 r/min mechanical limiting speed. Fit practice for NUP213-ECP: the loose inner-ring flange must be fitted on the correct side and retained by the shaft abutment; never omit it during reassembly or the bearing loses its two-direction locating function. Single-row cylindrical rollers tolerate only about 3–4 minutes of arc misalignment, so verify shaft and housing alignment.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Do not use a NUP bearing where a floating non-locating bearing is required — the loose inner flange makes it a locating bearing
• The dimension series 2 (light-section ISO 15 envelope) envelope is shared with the N/NU/NJ/NUP executions of 213, but flange configuration and axial-locating behaviour differ — quote the full SKF NUP 213 ECP and do not substitute rib styles without checking the shaft locating scheme.
• Shaft and housing fillets must clear the bearing chamfers; an oversized radius tilts the 23 mm-wide ring and concentrates load.
• Catalogue reference and limiting speeds are different criteria: observe the mechanical ceiling even when thermal calculations allow more.
• The 122/118 kN ratings are SKF catalogue 17000 (2018) values for the ECP execution; re-verify against the current catalogue for critical drives and keep the catalogue version with the specification.