SL014914 bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the SL014914 model number is decoded

envelope 70×100×30 mm with a 15.0 mm radial section; every available circumferential space carries a roller because there is no cage C is 106 kN and C0 185 kN; with a C/C0 ratio of 0.57 the 30 mm-wide full complement concentrates on extreme static and steady radial capacity rather than speed the fatigue load limit Cur is 27.5 kN, the limiting speed 3,900 r/min and the thermal reference speed 2,330 r/min — full-complement roller-to-roller contact keeps both speeds well below caged cylindrical bearings of the same size the dynamic rating is 1.51 kN per millimetre of the 70 mm bore and 3.53 kN per millimetre of the 30 mm width, figures that explain the use of this bearing in compact, heavily loaded gearbox positions mass is 780 g (0.26 g per mm² of the 100×30 mm envelope); the stiff, thick rings keep raceway deformation low under peak loads with a 70 mm bore this is a heavy-industrial bearing: 780 g of stiff ring and roller set, specified where rigidity matters more than speed As the fixed (locating) bearing it takes the thermal-expansion thrust from the shaft while the paired floating bearing moves; the limiting speed here is 3,900 r/min No angular compensation is built in: misalignment loads one roller row preferentially, so the housing and shaft seats for a 70 mm bore SL0149 must be machined parallel Typical applications include planetary gear bearing positions, construction machinery slewing drives and compact slow-speed agitator drives, where the 100 mm outside diameter and 106 kN dynamic rating match the duty. In planetary gear bearing positions the unit fits a compact 70 mm seat, and in construction machinery slewing drives the 780 g mass suits the compact, space-optimised housing. Designers also specify it for compact slow-speed agitator drives, relying on the 30 mm width and the published 185 kN static rating. Relubrication paths matter: specify the annular groove/hole executions where access is poor, because the tightly packed rows trap old grease. Press-fit the correct ring: the rotating ring needs interference while the floating ring must slide on its seat to perform the non-locating function.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Relubrication paths matter: specify the annular groove/hole executions where access is poor, because the tightly packed rows trap old grease.
• Press-fit the correct ring: the rotating ring needs interference while the floating ring must slide on its seat to perform the non-locating function.
• Use the rib structure correctly: SL18/SL1850 give one-direction axial guidance, SL0149 locates both ways and SL0249 floats — pairing two locating bearings on one shaft binds thermal growth.