SL014916 bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the SL014916 model number is decoded

envelope 80×110×30 mm with a 15.0 mm radial section; every available circumferential space carries a roller because there is no cage C is 112 kN and C0 206 kN; with a C/C0 ratio of 0.54 the 30 mm-wide full complement concentrates on extreme static and steady radial capacity rather than speed the fatigue load limit Cur is 30.5 kN, the limiting speed 3,550 r/min and the thermal reference speed 2,090 r/min — full-complement roller-to-roller contact keeps both speeds well below caged cylindrical bearings of the same size the dynamic rating is 1.40 kN per millimetre of the 80 mm bore and 3.73 kN per millimetre of the 30 mm width, figures that explain the use of this bearing in compact, heavily loaded gearbox positions mass is 880 g (0.27 g per mm² of the 110×30 mm envelope); the stiff, thick rings keep raceway deformation low under peak loads at 80 mm bore the 110 mm outside diameter and 30 mm width target rolling stands, construction machinery and heavy gearboxes; the limiting speed drops to 3,550 r/min The locating structure has an axially split outer ring with ribs on both sides, joined by retaining rings, and an inner ring with a centre rib — the 30 mm width houses two complete roller rows Inside the 80×110×30 mm envelope the two cageless rows provide C0 206 kN, the capacity this series is selected for in heavy gearbox and drum positions Typical applications include material handling conveyor pulleys, rolling-mill and steel-industry drives and construction machinery slewing drives, where the 110 mm outside diameter and 112 kN dynamic rating match the duty. In material handling conveyor pulleys the unit fits a compact 80 mm seat, and in rolling-mill and steel-industry drives the 880 g mass suits the compact, space-optimised housing. Designers also specify it for construction machinery slewing drives, relying on the 30 mm width and the published 206 kN static rating. C0 is the number that tempts overload in slow machinery, but fatigue life is still governed by the dynamic C rating and lubricant film. The bearings cannot accommodate angular misalignment; check shaft and housing parallelism before blaming the bearing for edge spalling.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• C0 is the number that tempts overload in slow machinery, but fatigue life is still governed by the dynamic C rating and lubricant film.
• The bearings cannot accommodate angular misalignment; check shaft and housing parallelism before blaming the bearing for edge spalling.
• Use the rib structure correctly: SL18/SL1850 give one-direction axial guidance, SL0149 locates both ways and SL0249 floats — pairing two locating bearings on one shaft binds thermal growth.