RNAO22X30X13-XL bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the RNAO22X30X13-XL model number is decoded

envelope 22×30×13 mm: 22 mm seat is the hardened and ground shaft journal itself — there is no inner ring, with a thin 4.0 mm radial section packed with small-diameter needle rollers C is 11.8 kN and C0 15.9 kN at the 22 mm seat; the C/C0 ratio of 0.74 is characteristic of a needle bearing — high static rating relative to dynamic in a compact 30 mm outside diameter the fatigue load limit Cur is 2.6 kN, the limiting speed 20,400 r/min and the thermal reference speed 12,400 r/min; for small needle bearings the reference speed can exceed the kinematic limit, so the lower of the two governs the application dynamic capacity per millimetre of bore is 0.54 kN/mm and per millimetre of width 0.91 kN/mm — the reason 13 mm-wide needle bearings routinely replace much larger ball or roller positions mass is 27 g, just 0.07 g per mm² of projected 30×13 mm envelope, which keeps unbalanced forces low in fast-actuating linkages the 22 mm bore falls in the small band, the workhorse size for gearbox planetary positions, hydraulic pumps and general cam and linkage duty Reading RNAO: O denotes the ribless (open-sided) race design; the single roller row runs directly between ground shaft and housing bore X-life status (-XL) indicates the current Schaeffler premium execution at 22 mm bore; the 15.9 kN C0 rating reflects the improved rolling-contact geometry. Typical applications include gearbox selector and change linkages, planetary gear bearings and copying and printing machine mechanisms, where the 30 mm outside diameter and 11.8 kN dynamic rating match the duty. In gearbox selector and change linkages the unit fits a compact 22 mm seat, and in planetary gear bearings the 27 g mass keeps unbalanced forces low in fast linkages. Designers also specify it for copying and printing machine mechanisms, relying on the 13 mm width and the published 15.9 kN static rating. Do not press an RNA/NK assembly in through the outer ring when mounting it on a shaft, and vice versa — rolling forces through the wrong ring bruises the raceways. Without an inner ring the shaft is the raceway: 58–64 HRC and a ground, polished journal are mandatory, not recommendations.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Do not press an RNA/NK assembly in through the outer ring when mounting it on a shaft, and vice versa — rolling forces through the wrong ring bruises the raceways.
• Without an inner ring the shaft is the raceway: 58–64 HRC and a ground, polished journal are mandatory, not recommendations.
• On reciprocating duty ensure the stroke rotates the full needle set, or brinelling occurs at the same roller positions.