KR-72-PPA bearing: complete specifications & equivalents

Specification table

Source: catalog reference (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 15 support rollers / ch. 16 cam followers) · extracted 2026-09-30

Parameters extracted from the official SKF Rolling Bearings catalogue (SKF PUB BU/P1 17000/1 EN (Oct 2018), ch. 15 support rollers / ch. 16 cam followers); SKF® and SKF Explorer® are trademarks of AB SKF, used here for identification only — mpnbase is not an authorized SKF distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at skf.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the KR-72-PPA model number is decoded

the 72 mm outside diameter runs on the track while the 24 mm stud shank takes the pin or shaft; the 80 mm overall width spreads the Hertzian contact over the outer ring published ratings C 26 kN and C0 48 kN already include the bending-stress correction for the unsupported outer ring — the C/C0 ratio of 0.54 is typical for cam follower with needle roller and cage executions fatigue load limit Pu 6 kN at 24 mm stud gives a specific load of 1.08 kN per mm; the limiting speed is 2,400 r/min the 80 mm width carries the load at 0.33 kN per mm of roller complement; section height 24.0 mm between stud and track surface determines the outer-ring bending stiffness mass 1000 g over a 72x80 mm envelope works out to 0.174 g per mm² of projected area — a useful figure when sizing the drive inertia for medium-speed cam duty the 24 mm stud diameter falls in the small-size band, the most common choice for general-purpose cam followers and light conveyor transfer rollers reading KR: cam follower with caged needle roller complement; the stud is threaded for the hexagonal nut and the outer ring profile is the track contact reading the PPA suffix: crowned outer ring — the track contact is barrel-shaped to tolerate angular misalignment between the roller axis and the track typical applications include automotive welding jig positioners, conveyor transfer and diverting rollers and woodworking machinery feed rollers this size is commonly specified for automotive welding jig positioners and conveyor transfer and diverting rollers, where the 72 mm track diameter and 24 mm stud fit standard cam and rail geometries in woodworking machinery feed rollers the 72 mm outer ring provides the rolling contact while the threaded stud simplifies mounting; the 1000 g mass is low enough for rapid indexing cycles the stud shank must be fully supported by the bracket; a cantilevered stud bends under load and misaligns the roller the cage-guided needle rollers are not suited to heavy shock — impact loads can crack the cage and release rollers

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• the single-row needle complement is the lightest cam follower option; do not overload it beyond the printed C rating
• the stud shank must be fully supported by the bracket; a cantilevered stud bends under load and misaligns the roller
• the stud head is relatively small; use a washer under the nut to spread the clamping load and prevent bracket surface damage