KR26-PP bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the KR26-PP model number is decoded

envelope 10×26×36 mm: the 26 mm outside diameter is the track-running surface — a thick-walled outer ring over a 10 mm stud — and the 36 mm overall stud-and-roller length sets the required bracket clearance the catalogue lists C 5.1 kN and C0 6.5 kN for the KR stud-type cam follower with needle roller and cage assembly; the C/C0 ratio of 0.78 reflects a rolling-element pack sized for heavy static track loading, and the 8.0 mm radial section gives the outer ring its bending stiffness fatigue load limit Cur is 0.86 kN at 10 mm stud, equivalent to 0.51 kN of dynamic rating per millimetre — the limiting speed is 8,000 r/min and, as for HR1 track rollers, no thermal reference speed is published the 10 mm threaded stud clamps directly into the machine bracket; over the roller running width the dynamic rating works out to 0.14 kN per millimetre of rolling-element complement within the 36 mm overall stud length mass is 57 g, or 0.06 g per mm² of the 26×36 mm track envelope — inertia that the drive must accelerate on every index of the cam 10 mm stud shank and only 57 g: the smallest sizes demand accurate shaft geometry, because the 8.0 mm section leaves no tolerance for a soft or tapered seat The crowned outer-ring profile is the standard form: it distributes edge stress when the cam track is not perfectly parallel, and a cylindrical-profile variant would be ordered separately Reading -PP: rubbing seals at each face of the 26 mm outer ring; they protect the rolling-element pack in abrasive track environments at the cost of a small drag torque. Typical applications include cam drives and indexing tables, printing press sheet-transfer grippers and woodworking machine feed tracks, where the 26 mm track diameter and 5.1 kN dynamic rating match the duty. In cam drives and indexing tables the threaded stud bolts directly to the frame, and in printing press sheet-transfer grippers the 57 g mass keeps follower kinetics light. Designers also specify it for woodworking machine feed tracks, relying on the 36 mm stud length and the published 6.5 kN static rating. Full-complement followers trade speed for static capacity — apply the lower limiting speed and expect higher drive torque than a caged KR. The stud must be fully supported and the nut torqued to the catalogue value; a loose follower wears the bracket hole oval and loosens further.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Full-complement followers trade speed for static capacity — apply the lower limiting speed and expect higher drive torque than a caged KR.
• The stud must be fully supported and the nut torqued to the catalogue value; a loose follower wears the bracket hole oval and loosens further.
• The eccentric collar throw is small (typically around 1 mm); it removes clearance, it cannot repair a grossly misplaced bracket.