KR62-PP bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the KR62-PP model number is decoded

envelope 24×62×80 mm: the 62 mm outside diameter is the track-running surface — a thick-walled outer ring over a 24 mm stud — and the 80 mm overall stud-and-roller length sets the required bracket clearance the catalogue lists C 26 kN and C0 48.5 kN for the KR stud-type cam follower with needle roller and cage assembly; the C/C0 ratio of 0.54 reflects a rolling-element pack sized for heavy static track loading, and the 19.0 mm radial section gives the outer ring its bending stiffness fatigue load limit Cur is 7 kN at 24 mm stud, equivalent to 1.08 kN of dynamic rating per millimetre — the limiting speed is 1,900 r/min and, as for HR1 track rollers, no thermal reference speed is published the 24 mm threaded stud clamps directly into the machine bracket; over the roller running width the dynamic rating works out to 0.33 kN per millimetre of rolling-element complement within the 80 mm overall stud length mass is 770 g, or 0.16 g per mm² of the 62×80 mm track envelope — inertia that the drive must accelerate on every index of the cam the 24 mm stud shank falls in the small band, the workhorse size for gearbox planetary positions, hydraulic pumps and general cam and linkage duty The crowned outer-ring profile is the standard form: it distributes edge stress when the cam track is not perfectly parallel, and a cylindrical-profile variant would be ordered separately C 26 kN, C0 48.5 kN and Cur 7 kN are the cam-contact ratings; the limiting speed is 1,900 r/min with no reference speed published The PP seals make this a maintenance-free unit: the 26 kN C rating is slightly below the open execution because the seal recesses shorten the effective roller complement. Typical applications include linear rail and profile track guidance, automatic assembly machine carriages and glass and ceramic line conveyors, where the 62 mm track diameter and 26 kN dynamic rating match the duty. In linear rail and profile track guidance the threaded stud bolts directly to the frame, and in automatic assembly machine carriages the 770 g mass keeps follower kinetics light. Designers also specify it for glass and ceramic line conveyors, relying on the 80 mm stud length and the published 48.5 kN static rating. On eccentric KRE/NUKRE/PWKRE units, re-torque after setting the collar — the adjustment changes the effective stud engagement. Full-complement followers trade speed for static capacity — apply the lower limiting speed and expect higher drive torque than a caged KR.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• On eccentric KRE/NUKRE/PWKRE units, re-torque after setting the collar — the adjustment changes the effective stud engagement.
• Full-complement followers trade speed for static capacity — apply the lower limiting speed and expect higher drive torque than a caged KR.
• Sealed PP/2RS followers are life-lubricated; open KR/NUKR executions need the stud greaseway serviced on a fixed interval.