KRV72-PP bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the KRV72-PP model number is decoded

envelope 24×72×80 mm: the 72 mm outside diameter is the track-running surface — a thick-walled outer ring over a 24 mm stud — and the 80 mm overall stud-and-roller length sets the required bracket clearance the catalogue lists C 36.5 kN and C0 86 kN for the KRV full-complement stud-type cam follower; the C/C0 ratio of 0.42 reflects a rolling-element pack sized for heavy static track loading, and the 24.0 mm radial section gives the outer ring its bending stiffness fatigue load limit Cur is 12.8 kN at 24 mm stud, equivalent to 1.52 kN of dynamic rating per millimetre — the limiting speed is 1,100 r/min and, as for HR1 track rollers, no thermal reference speed is published the 24 mm threaded stud clamps directly into the machine bracket; over the roller running width the dynamic rating works out to 0.46 kN per millimetre of rolling-element complement within the 80 mm overall stud length mass is 1.027 kg (1027 g), or 0.18 g per mm² of the 72×80 mm track envelope — inertia that the drive must accelerate on every index of the cam the 24 mm stud shank falls in the small band, the workhorse size for gearbox planetary positions, hydraulic pumps and general cam and linkage duty The stud must be fully supported and torqued against a flat bracket face; an under-supported cantilever stud bends under the 86 kN static rating and skews the outer ring -PP means sealed both sides with elastomer lips — the roller is greased for life and needs no relubrication fitting in the 80 mm width. Typical applications include printing press sheet-transfer grippers, glass and ceramic line conveyors and cam drives and indexing tables, where the 72 mm track diameter and 36.5 kN dynamic rating match the duty. In printing press sheet-transfer grippers the threaded stud bolts directly to the frame, and in glass and ceramic line conveyors the 1.027 kg mass is part of the rotor inertia calculation. Designers also specify it for cam drives and indexing tables, relying on the 80 mm stud length and the published 86 kN static rating. Full-complement followers trade speed for static capacity — apply the lower limiting speed and expect higher drive torque than a caged KR. Never hammer the stud or use the hex socket as a press point during mounting; thread or socket damage renders the 80 mm stud unusable.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Full-complement followers trade speed for static capacity — apply the lower limiting speed and expect higher drive torque than a caged KR.
• Never hammer the stud or use the hex socket as a press point during mounting; thread or socket damage renders the 80 mm stud unusable.
• On eccentric KRE/NUKRE/PWKRE units, re-torque after setting the collar — the adjustment changes the effective stud engagement.