RNA2206-2RSR bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the RNA2206-2RSR model number is decoded

envelope 35×62×19.8 mm: the 62 mm outside diameter is the track-running surface — a thick-walled outer ring over a 35 mm bore — and the 19.8 mm width sets the contact width on the mating track the catalogue lists C 17 kN and C0 26.5 kN for the RNA22 sealed yoke-type track roller without inner ring; the C/C0 ratio of 0.64 reflects a rolling-element pack sized for heavy static track loading, and the 13.5 mm radial section gives the outer ring its bending stiffness fatigue load limit Cur is 3.6 kN at 35 mm bore, equivalent to 0.49 kN of dynamic rating per millimetre — the limiting speed is 1,400 r/min and, as for HR1 track rollers, no thermal reference speed is published the 35 mm bore takes the mounting pin or shaft; across the 19.8 mm contact width the dynamic rating works out to 0.86 kN per millimetre of rolling-element complement mass is 284 g, or 0.23 g per mm² of the 62×19.8 mm track envelope — inertia that the drive must accelerate on every index of the cam at 35 mm pin bore this is a mainstream industrial size — conveyor drives, winches and medium gearboxes use the 19.8 mm width as a standard mounting space Choose RNA22 over RSTO where the environment carries abrasives: the 2RSR lips protect the needle complement but cannot be inspected or replaced without scrapping the unit The sealed 2RSR execution protects the rolling elements in dirty conveyors and cam drives; seal lip drag is the reason for the conservative speed rating. Typical applications include printing press sheet-transfer grippers, glass and ceramic line conveyors and cam drives and indexing tables, where the 62 mm track diameter and 17 kN dynamic rating match the duty. In printing press sheet-transfer grippers the unit fits a compact 35 mm seat, and in glass and ceramic line conveyors the 284 g mass keeps follower kinetics light. Designers also specify it for cam drives and indexing tables, relying on the 19.8 mm width and the published 26.5 kN static rating. Full-complement NATV/NUTR/PWTR rollers make heat and flat-spot easily — slow continuous rotation is fine, stationary load on a turning track is not. Yoke lugs must support the pin on both sides over its full length — single-sided support turns the pin into a cantilever beam.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Full-complement NATV/NUTR/PWTR rollers make heat and flat-spot easily — slow continuous rotation is fine, stationary load on a turning track is not.
• Yoke lugs must support the pin on both sides over its full length — single-sided support turns the pin into a cantilever beam.
• Flangeless STO/RSTO/RNA22/NA22 rollers need external axial location; circlips or shoulders must control end float or the roller walks off the track.