6319-2RS bearing: complete specifications & equivalents

Specification table

Source: catalog reference (SKF PUB BU/P1 17000/1 EN (Oct 2018)) · extracted 2026-09-24

Parameters extracted from the official SKF Rolling Bearings catalogue (SKF PUB BU/P1 17000/1 EN (Oct 2018)); SKF® and SKF Explorer® are trademarks of AB SKF, used here for identification only — mpnbase is not an authorized SKF distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at skf.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the 6319-2RS model number is decoded

6319-2RS is closed by two contacting elastomer lips over a lifetime grease fill; the lips add friction, so the speed ceiling sits below the open execution. Within the medium 63xx section (diameter series 3 of ISO 15), multiplying bore code 19 by five gives the 95 mm bore; the 200 mm outside diameter and 45 mm width follow the same boundary-dimension plan. For a rotating inner ring on a 95 mm shaft under normal load, catalogue practice seats it on a k5 shaft fit with an H7 housing bore — confirm against the actual load direction and magnitude before committing. SKF's contact-seal catalogue number is 6319-2RS1 (older text: -2RS1), mapped here from the industry-neutral -2RS spelling.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Large bores like the 95 mm of 6319-2RS demand clean, burr-free seats; one raised burr under a ring this size cocks the bearing and concentrates load at the raceway edge, cutting life drastically.
• The 63xx medium series gains rating at 95 mm bore through a 200 mm OD and 45 mm width; the heavier rolling elements also trade away some speed versus a 6219.
• Contact seals add drag and heat: 6319-2RS runs slower and cooler-limited than the open 6319; rubber lips are generally limited to roughly 80–110 °C continuous depending on grease, and C3 clearance is the common hot-duty choice.
• Never wash a sealed 6319-2RS in solvent or press it home via the outer ring; solvent destroys the grease thickener and mounting force through the seal deforms the lip.
• Shaft and housing fillets must clear the bearing chamfer so the 45 mm-wide ring seats square; provide an undercut or withdrawal groove instead of relying on an oversized radius.
• Deep-groove ball bearings tolerate only minutes of misalignment; if the 200 mm housing cannot be aligned, switch to a self-aligning type rather than shimming 6319-2RS.
• SKF catalogues the contact-sealed version as 6319-2RS1 (older printings may read -2RS1); it is shipped pre-greased and its 2200 r/min limiting speed is set by seal-lip drag and grease life versus the open bearing's 7000 r/min thermal reference speed. The single-seal catalogue number is 6319-RS1, used where one shaft side needs external relubrication.
• A one-seal execution 6319-RS1 exists for arrangements that lubricate through the open side; fitting 6319-2RS1 instead means lifetime grease and no external oil supply — mixing the two in the same shaft can starve the sealed position.
• The 159/118 kN ratings here are SKF Explorer-class figures from catalogue PUB BU/P1 17000/1 EN (Oct 2018); SKF can revise internal geometry and ratings without changing the designation, so treat the catalogue version and date as part of the specification and re-verify for critical drives.