N2207EA bearing: complete specifications & equivalents

Specification table

Source: catalog reference (NTN Ball and Roller Bearings CAT.No.2203E) · extracted 2026-10-01

Parameters extracted from the official NTN Ball and Roller Bearings catalogue (NTN Ball and Roller Bearings CAT.No.2203E); NTN® is a trademark of NTN Corporation, used here for identification only — mpnbase is not an authorized NTN distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at ntnglobal.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the N2207EA model number is decoded

For pure radial duty on a 35 mm shaft NTN supplies N2207EA: two integral ribs on the inner ring and a ribless separable outer ring; the open execution is rated 8,500 r/min on grease and 12,000 r/min on oil. Numbering ties N2207EA to its envelope: type code N, series N2200, 35 mm bore; the 72×23 mm outline therefore swaps dimensionally with other ISO 15 bearings of the same code, though rib arrangements differ by prefix. Line contact between rollers and raceways gives N2207EA high radial capacity but no tolerance for misalignment: beyond roughly 3–4 arc-minutes the roller ends edge-load and fatigue accelerates. Mass 405 g for the 35×72×23 mm N2207EA execution covers the pressed-steel cage and full roller complement; substitute on mass plus rating, not envelope alone. Housing and shaft fillets must clear the ring chamfers of N2207EA; an oversized radius locks the ring on its face and tilts the 23 mm-wide seat.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• On this 35 mm bore, shaft thermal growth can preload the inner ring if the fit is too tight; verify residual interference at temperature and confirm the float ring still slides after mounting N2207EA.
• The 18.5 mm section at 35 mm bore leaves a narrow oil path; with the EA pressed-steel-cage cage the relubrication groove and oil-level design must keep grease from churning in the 23 mm-wide cavity.
• The EA high-capacity roller complement changes the load figure versus the basic execution of the same number; the 73/65.5 kN pair here belongs to N2207EA as printed, not to the bare size.
• Wide (22/23) and light (10/49) executions at 35 mm bore share bore but not OD/width; check the full N2200 series code before substituting, because housing and shoulder geometry will not interchange.
• Wide (22/23) and light (10/49) executions at 35 mm bore share bore but not OD/width; check the full N2200 series code before substituting, because housing and shoulder geometry will not interchange.
• The 73/65.5 kN ratings, 7.95 kN Pu and 405 g mass are NTN Ball and Roller Bearings CAT.No.2203E values for N2207EA (EA pressed-steel-cage execution); other makes sharing the ISO 15 envelope revise internal geometry without changing the order number, so keep the 2203E reference with the specification for critical drives.