SL185007-XL bearing: complete specifications & equivalents

Specification table

Source: catalog reference (HR1 2026-09-25) · extracted 2026-09-30

Parameters extracted from the official FAG Rolling Bearings catalogue (HR1 2026-09-25); FAG® is a trademark of Schaeffler Technologies AG & Co. KG, used here for identification only — mpnbase is not an authorized FAG/Schaeffler distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at schaeffler.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the SL185007-XL model number is decoded

envelope 35×62×36 mm with a 13.5 mm radial section; every available circumferential space carries a roller because there is no cage C is 94 kN and C0 107 kN; with a C/C0 ratio of 0.88 the 36 mm-wide full complement concentrates on extreme static and steady radial capacity rather than speed the fatigue load limit Cur is 19.2 kN, the limiting speed 7,100 r/min and the thermal reference speed 4,750 r/min — full-complement roller-to-roller contact keeps both speeds well below caged cylindrical bearings of the same size the dynamic rating is 2.69 kN per millimetre of the 35 mm bore and 2.61 kN per millimetre of the 36 mm width, figures that explain the use of this bearing in compact, heavily loaded gearbox positions mass is 460 g (0.21 g per mm² of the 62×36 mm envelope); the stiff, thick rings keep raceway deformation low under peak loads the 35 mm bore places this bearing in the medium band, where the 62 mm envelope already carries ratings in the tens of kilonewtons SL1850 denotes the double-row full-complement semi-locating bearing: two roller rows share the 35 mm bore, and the arrangement guides the shaft axially in one direction while allowing displacement s in the other Two cageless roller rows inside the 62×36 mm envelope give C 94 kN and C0 107 kN — among the highest radial capacities available at the 35 mm bore As an X-life (-XL) bearing it benefits from the optimised surface finish that reduces friction and raises the fatigue strength behind the 19.2 kN Cur value. Typical applications include rope drums and winch drums, vibrating and oscillating machinery and marine and offshore winch arrangements, where the 62 mm outside diameter and 94 kN dynamic rating match the duty. In rope drums and winch drums the unit fits a compact 35 mm seat, and in vibrating and oscillating machinery the 460 g mass suits the compact, space-optimised housing. Designers also specify it for marine and offshore winch arrangements, relying on the 36 mm width and the published 107 kN static rating. Relubrication paths matter: specify the annular groove/hole executions where access is poor, because the tightly packed rows trap old grease. There is no cage: do not apply caged-bearing speed rules — the printed limiting speed is a hard kinematic ceiling set by roller-to-roller contact.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Relubrication paths matter: specify the annular groove/hole executions where access is poor, because the tightly packed rows trap old grease.
• There is no cage: do not apply caged-bearing speed rules — the printed limiting speed is a hard kinematic ceiling set by roller-to-roller contact.
• Use the rib structure correctly: SL18/SL1850 give one-direction axial guidance, SL0149 locates both ways and SL0249 floats — pairing two locating bearings on one shaft binds thermal growth.