6222-2RS bearing: complete specifications & equivalents

Specification table

Source: catalog reference (SKF PUB BU/P1 17000/1 EN (Oct 2018)) · extracted 2026-09-24

Parameters extracted from the official SKF Rolling Bearings catalogue (SKF PUB BU/P1 17000/1 EN (Oct 2018)); SKF® and SKF Explorer® are trademarks of AB SKF, used here for identification only — mpnbase is not an authorized SKF distributor. Boundary dimensions are ISO 15 interchangeable; current production values may differ, verify at skf.com.

Cross references & equivalents

Interchange levels: full standard interchange · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the 6222-2RS model number is decoded

6222-2RS is closed by two contacting elastomer lips over a lifetime grease fill; the lips add friction, so the speed ceiling sits below the open execution. Within the light 62xx section (diameter series 2 of ISO 15), multiplying bore code 22 by five gives the 110 mm bore; the 200 mm outside diameter and 38 mm width follow the same boundary-dimension plan. For a rotating inner ring on a 110 mm shaft under normal load, catalogue practice seats it on a m6 shaft fit with an H7 housing bore — confirm against the actual load direction and magnitude before committing. SKF's contact-seal catalogue number is 6222-2RS1 (older text: -2RS1), mapped here from the industry-neutral -2RS spelling.

Typical equipment & failure modes

Selection pitfalls — read before you substitute

• Large bores like the 110 mm of 6222-2RS demand clean, burr-free seats; one raised burr under a ring this size cocks the bearing and concentrates load at the raceway edge, cutting life drastically.
• The 62xx light series is the default general-purpose section at 110 mm bore; before upgrading to a 6322 for extra capacity, confirm the housing accepts a 200 mm OD and 38 mm width — it is not a drop-in swap.
• Heat is the enemy of the sealed 6222-2RS: sustained running near the lip temperature limit hardens the rubber, after which grease escapes and dirt tracks in — watch the housing temperature in hot drives.
• Never wash a sealed 6222-2RS in solvent or press it home via the outer ring; solvent destroys the grease thickener and mounting force through the seal deforms the lip.
• Measure the shaft, do not trust the drawing: a 110 mm nominal journal worn by even 0.02 mm turns an interference seat into a creeping fit that frets the bore of 6222-2RS.
• A 110 mm bore listing showing the right d/D/B but no standard or precision-class reference may be a loose-tolerance import; measure bore/OD spread before fitting it to a machined shaft.
• SKF catalogues the contact-sealed version as 6222-2RS1 (older printings may read -2RS1); it is shipped pre-greased and its 2000 r/min limiting speed is set by seal-lip drag and grease life versus the open bearing's 6700 r/min thermal reference speed. The single-seal catalogue number is 6222-RS1, used where one shaft side needs external relubrication.
• A one-seal execution 6222-RS1 exists for arrangements that lubricate through the open side; fitting 6222-2RS1 instead means lifetime grease and no external oil supply — mixing the two in the same shaft can starve the sealed position.
• The 151/118 kN ratings here are SKF Explorer-class figures from catalogue PUB BU/P1 17000/1 EN (Oct 2018); SKF can revise internal geometry and ratings without changing the designation, so treat the catalogue version and date as part of the specification and re-verify for critical drives.